Service Hotline: 13823761625

Support

Contact Us

You are here:Home >> Support >> Technology

Technology

A4964 Vehicle Code Certification Hall Free Sinusoidal Drive BLDC Controller

Time:2024-01-17 Views:367

    A4964 is a three-phase sensorless, brushless DC (BLDC) motor controller suitable for N-channel power MOSFETs, specifically designed for automotive applications. It is designed to provide motor control function for the system, in which the small microcontroller serves as the communication interface between the central ECU and intelligent fault and status processing. A4964 provides power and watchdog for the microcontroller, as well as a high-voltage interface between the microcontroller and the central ECU and ignition switch. A4964 can also function as an independent microcontroller for remote motor control. The motor is driven by a three-phase sine current driver, and this commutation does not require a separate position sensor. It can be determined by monitoring the back electromotive force of the motor. The sensorless startup scheme includes forward and reverse pre rotation (wind power generation) detection and synchronization, and makes A4964 suitable for various motor and load combinations. A4964 operates using duty cycle (voltage) control, current (torque limitation) control, and closed-loop speed control. The control mode, working mode, and control parameters are programmed through an SPI compatible serial interface. The single current detection amplifier provides peak current limitation and average current measurement through a serial interface. Integrated diagnosis provides indication of undervoltage, overheating, and power bridge faults, and can protect the power switch in most short circuit conditions. A4964 is packaged with 36 terminal QFN and 32 pin QFP, both with exposed heat dissipation pads.
    Suitable for applications: automotive fuel, oil pumps, automotive fans and blowers, etc
Main advantages:
    FET driver for three-phase sensorless brushless DC motor control
    Three phase sine drive with soft start
    Sensorless start and commutation
    Wind power detection and synchronization
     Bootstrap gate drive for N-channel MOSFET bridges
    5.5 to 50V power supply voltage
    SPI compatible interface
    Programmable control modes: speed, voltage, current
    Peak current limit
    Controlled through SPI or PWM
    Programmable gate drive for commutation rate control
    LIN/PWM physical interface with wake-up function
    Logic power regulator with current control
    MCU watchdog and reset
    Ignition switch interface
    Diagnosis, status, current, and speed feedback












   
      
      
   
   


    Disclaimer: This article is transferred from other platforms and does not represent the views and positions of this site. If there is any infringement or objection, please contact us to delete it. thank you!
    矽源特科技ChipSourceTek